Mastercool 53412 RECHARGEABLE UV LIGHT (12V_50 WATT) User Manual download pdf

LEAK DETECTION USING A

RECHARGEABLE UV FLASHLIGHT

SAFETY INSTRUCTIONS FOR CHARGER AND BATTERY CARTRIDGE

1. DO NOT charge battery cartridge when temperature is BELOW 10˚C

(50˚F) or ABOVE 40˚C (104˚F). Keep charger vents CLEAR.

2. To prevent large current ﬂow, overheating or possible burns:

• DO NOT touch terminals with conductive material.

• Avoid storing batteries with metals.

• DO NOT expose battery cartridge to water or rain.

3. DO NOT incinerate the battery cartridge even if it is badly damaged

or is completely worn out. The battery cartridge can explode in a ﬁre.

4. An extension cord should NOT be used unless absolutely necessary.

Use of improper extension cord could result in a risk of ﬁre and

electric shock. If extension must be used, make sure the extension

cord is properly wired and in good electrical condition, and the wire

size is at least as large as the one speciﬁed in the table below:

Minimum AWG Size for Extension Cords for Battery Chargers

Length of Cord (Feet) 25 50 100 150

AWG Size of Cord 18 18 18 16

CHARGING

Your new battery cartridge is not charged. You will need to charge it

before use. Plug the battery charger into the proper AC voltage source.

Insert the battery cartridge so that the plus and minus terminals

correspond with the markings on the battery charger.

When the battery cartridge is inserted, the red charging light will go on

and charging will begin. The red light will remain on during this process.

When charging is completed, the green light will go on. Charging will

take approximately 1 1/2 to 2 hrs. When ﬁnished, unplug the charger

from the power source.

When you charge a new battery cartridge or a cartridge which has not

been used for a long period of time, it may not accept a full charge. This

is a normal condition and does not indicate a problem. You can recharge

the battery cartridge fully after discharging it completely and recharging

a couple of times.

If you wish to charge a second battery cartridge, allow 30 minutes

between charging on the battery charger.

Rechargeable

UV Flashlight

12 V

BATT ERY CHAR GER

Battery Charger

Battery Cartridge

LEAK DETECTION USING A UV LAMP

1. Turn Engine and A/C system on.

2. Allow dye to circulate throughout system.

3. Insert the battery cartridge into the UV Flashlight. (Make sure the

battery is fully charged).

4. WEAR PROTECTIVE GLASSES!!

5. Do not use lamp near ﬂammable materials, liquids or gases.

6. Never use lamp for more than 3 minutes at a time. Allow lamp to cool

between uses, 3 MINUTES ON, 5 MINUTES OFF. If used continuously,

you may damage glass lens.

7. Turn lamp on. Search for a bright green/yellow glow where the system

is leaking. Clean the area around leak after repair.

53400-INS

Summary of Contents

Page 1 - RECHARGEABLE UV FLASHLIGHT

LEAK DETECTION USING A RECHARGEABLE UV FLASHLIGHTSAFETY INSTRUCTIONS FOR CHARGER AND BATTERY CARTRIDGE1. DO NOT charge battery cartridge when tempera

Comments to this Manuals

No comments

Mastercool 53412 RECHARGEABLE UV LIGHT (12V_50 WATT) User Manual

Browse online or download User Manual for Equipment Mastercool 53412 RECHARGEABLE UV LIGHT (12V_50 WATT). Mastercool 53412 RECHARGEABLE UV LIGHT (12V_50 WATT) User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Mastercool 53412 RECHARGEABLE UV LIGHT (12V_50 WATT)